- You do not have any products in your shopping cart yet.
Emitter Chip, 6W
Dot LED chip in RED, GREEN, WHITE, WARM WHITE
High-performance LED module with 6Wx2 reference power for the installation of flashing and flashing lights. Ready-made for operation on 2S Lipo (approx. 8V). When operating with 3S (12V), the enclosed resistor must be used.
When building your own lights, always pay attention to the heat development. These high-performance LED chips cannot be operated without cooling. Use additional heat sinks or reduce the power if you want to implement a position light, for example. This can also be done, for example, by using the 3S resistor on 2S (approx. 20-30% reduction). Note that LED systems should not be heated above 70 ° C.
High-performance LED module with 6Wx2 reference power for the installation of flashing and flashing lights. Ready-made for operation on 2S Lipo (approx. 8V). When operating with 3S (12V), the enclosed resistor must be used.
When building your own lights, always pay attention to the heat development. These high-performance LED chips cannot be operated without cooling. Use additional heat sinks or reduce the power if you want to implement a position light, for example. This can also be done, for example, by using the 3S resistor on 2S (approx. 20-30% reduction). Note that LED systems should not be heated above 70 ° C.
Electricity: 6Wx2 reference power, 8(12)V, 0.5A
Beam angle: ~120°
Light intensity: ~175 Lumen RED
Light intensity: ~250 Lumen RED
Light intensity: ~475 Lumen WHITE
Light intensity: ~475Lumen WARMWHITE
Dimension: D22, LED-Chip D5x5mm
Weight: 2g (without cable)
Beam angle: ~120°
Light intensity: ~175 Lumen RED
Light intensity: ~250 Lumen RED
Light intensity: ~475 Lumen WHITE
Light intensity: ~475Lumen WARMWHITE
Dimension: D22, LED-Chip D5x5mm
Weight: 2g (without cable)
Ready to use with 1m connection cable and series resistor for 2S, resistor for 3S enclosed
The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
TECHNICAL INFORMATION
CONNECTION
CONNECTION
Customer reviews
Unfortunately there are no review yet. Be the first who rate this product.
You must be logged in to submit a review. Login
