- You do not have any products in your shopping cart yet.
19mm ROUND Navigation Light, 8Wx2, T-Fuse
Power Navigation Light with 19mm diameter!
Multi-chip design allows extremely good light output with a compact design and low heat loss. Best light output in size with integrated thermal fuse.
The new round lights are supplied with a snap-on 19mm cap made of highly transparent polycarbonate. The faceted cap results in a perfect radiation over the entire horizon. Without the cap, the installation can be done very easily in margins and prefabricated recesses.
Electricity: 8W reference power with x2-technology, 8V/12V, 0.65A
Beam angle: 180°
Light intensity: ~220 Lumen RED
Light intensity: ~320 Lumen GREEN
Light intensity: ~550 Lumen WHITE
Dimension: D19x42mm
Weight: 12g (without cable)
Beam angle: 180°
Light intensity: ~220 Lumen RED
Light intensity: ~320 Lumen GREEN
Light intensity: ~550 Lumen WHITE
Dimension: D19x42mm
Weight: 12g (without cable)
With 1m silicone connection cable, ready for connection for 8V/2S Lipo. Already mounted with 2 high quality polycarbonat caps (1xball,1xcylindrical), additional resistor for 12V/3S operation
The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
TECHNICAL INFORMATION
CONNECTION
CONNECTION
Customer reviews
Unfortunately there are no review yet. Be the first who rate this product.
You must be logged in to submit a review. Login
